Servo Programmer/Tester








				ServoCity - Electronics & Accessories - Servo Programmer/Tester

Welcome the the world of high performance servo technology. Using this HRP-20 digital servo programmer and servo tester, you can test any brand of transmitter for the pulse sent to the receiver and any servo for voltage and proper movement. Additionally, it will allow you to program the functions for Hitec brand digital servos. If you use digital servos, you need this unit to maximize your investment. (This unit will not program Futaba or JR digital servos). View the function chart below to see all the perimeters you can set using this programmer.

Price:

$154.99

Part:

44430

Status:

Qty:




	The back of the programmer has instructions printed directly on the case.


		Functions: Reset to factory defaults Set overload protection settings Set resolution modes Set the deadband width Set the direction of rotation Increase/Decrease rotation speed Fail Safe on/off Set the endpoint of each servo Set the neutral point of each servo Measure the receiver pulse to the servo Measure the receiver voltage to the servo Automatic servo movement test program Manual servo movement test program

	Be sure to check out our new Servo Protractor (angle tester). Works perfect for setting up multiple digital servos to the same angle.


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.